Hi,
We started to test out ThinApp to capture some application on a windows 10 pro VM machine. This is only a trial.
1) We tested to capture SAPGUI as following
Inventory Name: SAPLogon
Project Location: C:\Capture
Then we tested the build package and it was running fine in a share folder.
We are able to launch the SAPLogon without issue from remote computer.
2) Now, we want to include a single sign on tool into this SAPGUI as both must be in the same build in order for the SAPLogon single sign on to work.
Question:
2.1) I start the setup capture pre-scan, install the single sign on tool and post-scan, after that I was asked to enter
Inventory Name:
Project Location:
Can I used back the same setting as below. I am getting a message whether I would like to overwrite the Project Location. I am not too sure about this.
Inventory Name: SAPLogon
Project Location: C:\Capture
3) What I would like to do is to combine both SAPLogon and the single sign on into 1 single build package.
Since I already have existing Project Location and Inventory Name, how should I go about it?
Appreciate any help and advice here.