Hi,
I need to update a thinapp capture. I have in the past used a method to reload the original captured machine state back into a back into a clean machine at the point of the app having being installed and configured, but before being recorded and built. This was not a start from scratch and re-run the full setup, or run the thinapp'd package and make the changes then run sbmerge print - sbmerge apply, but a way to run setup capture to capture the base state of the machine then load the previously captured package into that machine to get it to the point where you had tun the install and made all configuration changes, then make the changes and run the setup capture end and build routine.
I remember there was an article that included instructions on how to do this, but I can't find it now. Can anyone point me in the right direction please.
Thanks